Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

1234 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
24
router ospf
network 1.2.3.0/24 area 4.5.6.7
area 0.0.0.4
auto-cost reference-bandwidth 1
default-information originate metric 1 metric-type 2
ip default-gateway priority 1
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#
Related Commands:
ospf
router-mode
Enables OSPF routing on a profile or device
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
ospf enable
Parameters
ospf enable
Example
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#ospf enable
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#show context
router ospf
ospf enable
network 1.2.3.0/24 area 4.5.6.7
area 0.0.0.4
auto-cost reference-bandwidth 1
default-information originate metric 1 metric-type 2
ip default-gateway priority 1
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#
Related Commands:
passive
router-mode
no Removes the OSPF network to area ID association
ospf enable Enables OSPF routing on devices using this profile. This option is disabled by default.
no Disables OSPF routing on a profile or device