Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

1224 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
24
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#
router-mode
ROUTER-MODE COMMANDS
Table 22 summarizes router configuration commands.
area
router-mode
Configures OSPF network area (OSPF enabled interfaces) settings
The following table lists the OSPF Area configuration mode commands.
area
area
Configures OSPF network areas (OSPF enables interfaces)
TABLE 22 OSPF-Router Config Commands
Command Description Reference
area Specifies OSPF enabled interfaces page 1224
auto-cost Specifies the reference bandwidth in terms of Mbits per second page 1230
default-information Controls the distribution of default information page 1231
ip Configures Internet Protocol (IP) default gateway priority page 1232
network Defines OSPF network settings page 1233
ospf Enables OSPF page 1234
passive Specifies the configured OSPF interface as passive interface page 1234
redistribute Specifies the route types redistributed by OSPF page 1235
route-limit Specifies the limit for the number of routes managed by OSPF page 1236
router-id Specifies the router ID for OSPF page 1237
vrrp-state-check Publishes interface via OSPF based on VRRP status page 1238
no Negates a command or sets its defaults page 1239
Command Description Reference
area Creates a new OSPF area and enters its configuration mode page 1224
OSPF-area-mode Summarizes OSPF area configuration commands page 1226