Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 1221
53-1003098-01
23
Example
rfs7000-37FABE(config-profile
default-rfs7000-l2tpv3-manual-session-test)#remote-session-id 200
rfs7000-37FABE(config-profile
default-rfs7000-l2tpv3-manual-session-test)#show context
l2tpv3 manual-session test
local-ip-address 1.2.3.4
peer ip-address 5.6.7.8 udp port 150
local-session-id 1
remote-session-id 200
remote-cookie size 8 400 700
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-manual-session-test)#
Related Commands:
traffic-source
l2tpv3-manual-session-commands
Configures the traffic source tunneled by this session
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
traffic-source vlan <VLAN-ID-RANGE> {native-vlan <1-4094>}
Parameters
traffic-source vlan <VLAN-ID-RANGE> {native-vlan <1-4094>}
Example
rfs7000-37FABE(config-profile
default-rfs7000-l2tpv3-manual-session-test)#traffic-source vlan 50-60
native-vlan 2
rfs7000-37FABE(config-profile
default-rfs7000-l2tpv3-manual-session-test)#show context
l2tpv3 manual-session test
local-ip-address 1.2.3.4
no Removes the manual session’s remote ID
traffic-source vlan
<VLAN-ID-RANGE>
Configures VLAN as the traffic source for this tunnel
• <VLAN-ID-RANGE> – Configures VLAN range list of traffic source. Specify the VLAN IDs as a range (for
example, 10-20, 25, 30-35)
native-vlan <1-4094> Optional – Configures the native VLAN ID for this session, which is not tagged
• <1-4094> – Specify the native VLAN ID from 1- 4094.