Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 1213
53-1003098-01
23
rfs7000-37FABE(config-profile-default-rfs7000)#l2tpv3 manual-session test
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-manual-session-test)#
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-manual-session-test)#?
L2tpv3 Manual Session Mode commands:
local-cookie The local cookie for the session
local-ip-address Configure the IP address for tunnel. If not specified,
tunnel source ip address would be chosen automatically
based on the tunnel peer ip address
local-session-id Local session id for the session
mtu Configure the mtu size for the tunnel
no Negate a command or set its defaults
peer Configure L2TPv3 manual session peer
remote-cookie The remote cookie for the session
remote-session-id Remote session id for the session
traffic-source Traffic that is tunneled
clrscr Clears the display screen
commit Commit all changes made in this session
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-manual-session-test)#
The following table summarizes L2TPv3 manual session configuration commands.
Command Description Reference
local-cookie Configures the manual session’s local cookie field size page 1214
local-ip-address Configures the manual session’s local source IP address page 1214
local-session-id Configures the manual session’s local session ID page 1215
mtu Configures the MTU size for the manual session tunnel page 1216
no Negates or reverts L2TPv3 manual session commands to default page 1205
peer Configures the manual session’s peers page 1218
remote-cookie Configures the remote cookie for the manual session page 1219
remote-session-id Configures the manual session’s remote session ID page 1220
traffic-source Configures the traffic source tunneled by the manual session page 1221
clrscr Clears the display screen page 385
commit Commits (saves) changes made in the current session page 386
end Ends and exits the current mode and moves to the PRIV EXEC mode page 234
exit Ends the current mode and moves to the previous mode page 387
help Displays the interactive help system page 387
revert Reverts changes to their last saved configuration page 394
service Invokes service commands to troubleshoot or debug
(config-if) instance
configurations
page 394