Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

ManualsBrandsBrocade ManualsComputer AccessoriesMobility RFS Controller CLI

1211

Brocade Mobility RFS Controller CLI Reference Guide 1207

53-1003098-01

Related Commands:

peer

l2tpv3-tunnel-commands

Configures the L2TPv3 tunnel’s peers. At least one peer must be specified.

Supported in the following platforms:

• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,

Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade

Mobility 1240 Access Point

• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade

Mobility RFS7000

• Service Platforms — Brocade Mobility RFS9510

Syntax:

peer <1-2> {hostname|ip-address|ipsec-secure|router-id|udp}

peer <1-2> {hostname [<HOSTNAME>|any]} {ipsec-secure|router-id|udp}

peer <1-2> {ip-address <IP>} {hostname|ipsec-secure|router-id|udp}

peer <1-2> {ipsec-secure} {gw [<IP>|<WORD>]}

peer <1-2> {router-id [<IP>|<WORD>|any]} {ipsec-secure|udp}

peer <1-2> {udp} {ipsec-secure|port <1-65535>}

Parameters

peer <1-2> {hostname [<HOSTNAME>|any]} {ipsec-secure|router-id|udp}

establishment-criteria Configures a L2TPv3 tunnel’s establishment criteria

hostname Configures the tunnel’s local hostname

local-ip-address Configures the tunnel’s source IP address

mtu Configures the MTU size for this tunnel

peer Configures the tunnel’s peers

router-id Configures the tunnel’s local router ID

session Creates/modifies specified L2TPv3 session

use Associates a specified L2TPv3 tunnel policy with a L2TPv3 tunnel

peer <1-2> Configures the tunnel’s peer ID from 1 - 2

NOTE: At any time the tunnel is established with only one peer.

hostname

[<HOSTNAME>|any]

Optional. Configures the peers’ hostname. The hostname options are:

• <HOSTNAME> – Specifies the hostname as Fully Qualified Domain Name (FQDN) or partial DN or

any other name

• any – Peer name is not specified. If the hostname is ‘any’ this tunnel is considered as responder

only and will allow incoming connection from any host.

ipsec-secure

{gw [<IP>|<WORD>]}

After specifying the peer hostname, optionally specify the IPSec settings:

• ipsec-secure – Optional. Enables auto IPSec

• gw – Optional. Configures IPSec gateway IP address or hostname

• <IP> – Configures IPSec gateway’s IP address

• <WORD> – Configures IPSec gateway’s hostname