Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 1191
53-1003098-01
23
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#
Table 21 summarizes L2TPv3 policy configuration commands.
cookie-size
l2tpv3-policy-commands
Configures the size of the cookie field present in each L2TPv3 data packet. L2TPv3 data packets
contain a session cookie that identifies the session (pseudowire) corresponding to it. In a tunnel,
the cookie is a 4-byte or 8-byte signature shared between the two tunnel endpoints. This signature
is configured at both the source and destination routers. If the signature at both ends do not
match, the data is dropped. All sessions within a tunnel have the same session cookie size.
Supported in the following platforms:
TABLE 21 L2TPV3-Tunnel-Policy-Config Commands
Command Description Reference
cookie-size Configures the cookie field size for each L2TPv3 data packet page 1191
failover-delay Configures the L2TPv3 tunnel failover delay in seconds page 1192
force-12-path-recovery Enables the forced detection of servers and gateways behind the L2TPv3 tunnel page 1193
hello-interval Configures the interval, in seconds, between L2TPv3 “Hello” keep-alive messages
exchanged in the L2TPv3 control connection
page 1194
no Negates or reverts L2TPv3 tunnel commands page 1195
reconnect-attempts Configures the maximum number of retransmissions for signalling messages page 1196
reconnect-interval Configures the interval, in seconds, between successive attempts to re-establish a failed
tunnel connection
page 1197
retry-attempts Configures the maximum number of retransmissions of signalling messages page 1198
retry-interval Configures the interval, in seconds, before initiating a retransmission of any L2TPv3
signalling message
page 1198
rx-window-size Configures the number of signalling messages received without sending an
acknowledgment
page 1199
tx-window-size Configures the number of signalling messages transmitted without receiving an
acknowledgment
page 1200
clrscr Clears the display screen page 385
commit Commits (saves) changes made in the current session page 386
end Ends and exits the current mode and moves to the PRIV EXEC mode page 234
exit Ends the current mode and moves to the previous mode page 387
help Displays the interactive help system page 387
revert Reverts changes to their last saved configuration page 394
service Invokes service commands to troubleshoot or debug
(config-if) instance
configurations
page 394
show Displays running system information page 429