Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

1170 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
21
Usage Guidelines:
The
no command negates any command associated with it. Wherever required, use the same
parameters associated with the command getting negated.
Example
The following is the WIPS signature ‘test’ settings before the execution of
the ‘no’ command:
rfs7000-37FABE(config-test-signature-test)#show context
signature test
bssid 11-22-33-44-55-66
src-mac 00-1E-E5-EA-1D-60
dst-mac 55-66-77-88-99-00
frame-type beacon
ssid-match ssid PrinterLan
filter-ageout 8
threshold-client 88
threshold-radio 88
payload 1 pattern brocade offset 1
rfs7000-37FABE(config-test-signature-test)#
The following is the WIPS signature ‘test’ settings after the execution of the
‘no’ command:
rfs7000-37FABE(config-test-signature-test)#no mode enable
rfs7000-37FABE(config-test-signature-test)#no bssid
rfs7000-37FABE(config-test-signature-test)#no dst-mac
rfs7000-37FABE(config-test-signature-test)#no src-mac
rfs7000-37FABE(config-test-signature-test)#no filter-ageout
rfs7000-37FABE(config-test-signature-test)#no threshold-client
rfs7000-37FABE(config-test-signature-test)#no threshold-radio
rfs7000-37FABE(config-test-signature-test)#
signature test
no mode enable
frame-type beacon
payload 1 pattern brocade offset 1
rfs7000-37FABE(config-test-signature-test)
Related Commands:
no threshold-client Removes the wireless client threshold limit configured with a WIPS policy. When the wireless client
exceeds the specified limit, an event is triggered.
no threshold-radio Removes a radio threshold limit configured with a WIPS policy. When the radio exceeds the specified
threshold limit, an event is triggered.
bssid Configures a WIPS signature BSSID MAC address
dst-mac Configures a destination MAC address for the packet examined for matching
filter-ageout Configures the filter ageout interval
frame-type Configures the frame type to match with a signature
interference-event Specifies events contributing to the Smart RF WiFi interference calculations
mode Enables or disables a WIPS signature