Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual
Brocade Mobility RFS Controller CLI Reference Guide 1169
53-1003098-01
21
rfs7000-37FABE(config-test-signature-test)#
Related Commands:
no
signature mode commands
Negates a command or resets settings to their default. When used in the config WIPS policy
signature mode, the
no command resets or removes WIPS signature settings.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no
[bssid|dst-mac|filter-ageout|frame-type|interference-event|mode|payload|src-m
ac|
ssid-match|threshold-client|threshold-radio]
no [bssid|dts-mac|filter-ageout|frame-type|interference-event|mode enable|
payload <1-3>|src-mac|ssid-match
[ssid|ssid-len]|threshold-client|threshold-radio]
Parameters
no [bssid|dst-mac|filter-ageout|frame-type|interference-event|mode enable|
payload <1-3>|src-mac|ssid-match
[ssid|ssid-len]|threshold-client|threshold-radio]
no Removes the radio’s threshold limit configured with a WIPS policy signature
no bssid Disables a WIPS signature BSS ID
no dst-mac Disables a WIPS signature destination MAC address
no filter-ageout Removes the filter ageout interval. This is the duration a client, triggering a WIPS event, is excluded from
RF Domain manager radio association.
no frame-type Removes a WIPS signature frame type
no interference-event Disables this WIPS policy signature as a Smart RF interference source
no mode enable Disables a WIPS signature
• enable – Changes the mode from enabled to disabled
no payload <1-3> Removes payload index and associated settings. The payload command sets a numerical index pattern
and offset for this WIPS signature
• <1-3> – Sets the payload index
no src-mac Removes a WIPS signature source MAC address
no ssid-match
[ssid|ssid-len]
Removes the configured SSID and the SSID character length
• ssid – Removes the specified SSID match string
• ssid-len – Removes the specified character length of the SSID