Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

ManualsBrandsBrocade ManualsComputer AccessoriesMobility RFS Controller CLI

1171

Brocade Mobility RFS Controller CLI Reference Guide 1163

53-1003098-01

frame-type

reassoc]

Parameters

frame-type

reassoc]

Usage Guidelines:

The frame type configured determines the SSID match type configured. To configure the SSID

match type as SSID, the frame type must be beacon, probe-req or probe-resp.

Example

rfs7000-37FABE(config-test-signature-test)#frame-type reassoc

rfs7000-37FABE(config-test-signature-test)#show context

signature test

bssid 11-22-33-44-55-66

dst-mac 55-66-77-88-99-00

frame-type reassoc

filter-ageout 8

rfs7000-37FABE(config-test-signature-test)#

Related Commands:

interference-event

signature mode commands

Configures this WIPS policy signature as Smart RF interference source

Supported in the following platforms:

• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,

Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade

Mobility 1240 Access Point

frame-type Configures the frame type used for matching

all Configures all frame type matching

assoc Configures association frame matching

auth Configures authentication frame matching

beacon Configures beacon frame matching

data Configures data frame matching

deauth Configures deauthentication frame matching

disassoc Configures disassociation frame matching

mgmt Configures management frame matching

probe-req Configures probe request frame matching

probe-resp Configures probe response frame matching

reassoc Configures re-association frame matching

no Resets a WIPS signature frame type