Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

1160 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
21
The following table summarizes WIPS policy signature configuration mode commands.
bssid
signature mode commands
Configures a BSSID MAC address with this WIPS signature for matching
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
bssid <MAC>
Parameters
Commands Description Reference
bssid Configures the BSSID MAC address page 1160
dst-mac Configures the destination MAC address page 1161
filter-ageout Configures the filter ageout interval page 1162
frame-type Configures the frame type used for matching page 1162
interference-event Configures this WIPS policy signature as the Smart RF interference source page 1163
mode Enables or disables the signature mode page 1164
payload Configures payload settings page 1165
src-mac Configures the source MAC address page 1165
ssid-match Configures a match based on SSID page 1166
threshold-client Configures the wireless client threshold limit page 1167
threshold-radio Configures the radio threshold limit page 1168
no Negates a command or sets its default page 1169
clrscr Clears the display screen page 385
commit Commits (saves) changes made in the current session page 386
end Ends and exits the current mode and moves to the PRIV EXEC mode page 234
exit Ends the current mode and moves to the previous mode page 387
help Displays the interactive help system page 387
revert Reverts changes to their last saved configuration page 394
service Invokes service commands to troubleshoot or debug
(config-if) instance
configurations
page 394
show Displays running system information page 429
write Writes information to memory or terminal page 425