Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

1158 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
21
rfs7000-37FABE(config-wips-policy-test)#
Related Commands:
signature
wips-policy
Attack and intrusion patterns are identified and configured as signatures in a WIPS policy. The
WIPS policy compares packets in the network with pre configured signatures to identify threats.
The following table summarizes WIPS policy signature configuration commands.
signature
signature
Configures a WIPS policy signature
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
signature <SIGNATURE-NAME>
Parameters
signature <SIGNATURE-NAME>
br-detection Enables the detection of unauthorized or unsactioned access points
enable Enables a WIPS policy for use with a profile
event Configures events, filters, and threshold values for a WIPS policy
history-throttle-duration Configures the duration event duplicates are omitted from the event history
interference-event Specifies events contributing to the Smart RF WiFi interference calculations
signature Configures a WIPS policy signature
use Enables the categorization of devices on this WIPS policy
signature Configures a WIPS policy signature and enters its configuration mode page 1158
signature mode
commands
Summarizes WIPS signature configuration mode commands page 1159
signature
<SIGNATURE-NAME>
Configures a WIPS policy signature
• <SIGNATURE-NAME> – Enter a name for the WIPS policy signature. The name should not exceed 64
characters.