Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 1139
53-1003098-01
20
rfs7000-37FABE(config-smart-rf-policy-test)#no neighbor-recovery
power-threshold 5GHz
rfs7000-37FABE(config-smart-rf-policy-test)#no assignable-power 5GHz min
rfs7000-37FABE(config-smart-rf-policy-test)#no assignable-power 5GHz max
The following example shows the Smart RF policy ‘test’ settings after the ‘no’
commands are executed:
rfs7000-37FABE(config-smart-rf-policy-test)#show context
smart-rf-policy test
area test channel-list 2.4GHz 1,2,3
group-by floor
sensitivity custom
channel-list 2.4GHz 1,12
channel-width 5GHz auto
coverage-hole-recovery snr-threshold 5GHz 1
rfs7000-37FABE(config-smart-rf-policy-test)#
Related Commands:
sensitivity
smart-rf-policy
Configures Smart RF sensitivity level. The sensitivity level determines Smart RF scanning and
sampling aggressiveness. For example, a low sensitivity level indicates a less aggressive Smart-RF
policy. This translates to fewer samples taken during off-channel scanning and short off-channel
durations. When the sensitivity level is set to high, Smart-RF collects more samples, and remains
off-channel longer.
The Smart RF sensitivity level options include low, medium, high, and custom. Medium, is the
default setting. The custom option allows an administrator to adjust the parameters and thresholds
for interference recovery, coverage hole recovery, and neighbor recovery. However, the low,
medium, and high settings still allow utilization of these features.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
area Specifies the channel list and power for a specified area
assignable-power Assigns the power range
channel-list Assigns the channel list for the selected frequency
channel-width Selects the channel width for Smart RF configuration
coverage-hole-recovery Enables recovery from coverage hole errors
enable Enables the configured Smart RF policy features
group-by Configures grouping parameters on this Smart RF policy
interference-recovery Enables recovery of errors due to excessive noise and interference
neighbor-recovery Enables recovery of faulty neighbor radios
smart-ocs-monitoring Applies smart off channel scanning instead of dedicated detectors