Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

1016 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
16
rfs7000-37FABE(config-management-policy-test)#?
Management Mode commands:
aaa-login Set authentication for logins
banner Define a login banner
ftp Enable FTP server
http Hyper Text Terminal Protocol (HTTP)
https Secure HTTP
idle-session-timeout Configure idle timeout for a configuration session
(GUI or CLI)
no Negate a command or set its defaults
privilege-mode-password Set the password for entering CLI privilege mode
restrict-access Restrict management access to the device
snmp-server SNMP
ssh Enable ssh
telnet Enable telnet
user Add a user account
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-management-policy-test)#
management-policy
Table 14 summarizes management policy configuration commands.
TABLE 14 Management-Policy-Config Commands
Command Description Reference
aaa-login Configures login authentication settings page 1017
banner Configures the message of the day (motd) text page 1018
ftp Enables FTP on this management policy page 1019
http Enables HTTP on this management policy page 1021
https Enables HTTPS on this management policy page 1021
idle-session-timeout Sets the interval after which an idle session is terminated page 1022
no Removes or resets this management policy’s settings page 1023
privilege-mode-passwor
d
Configures the CLI’s privilege mode access password page 1026
restrict-access Restricts management access to a set of hosts or subnets page 1027
snmp-server Sets the SNMP server settings on this management policy page 1029
ssh Enables SSH on this management policy page 1033
telnet Enables Telnet on this management policy page 1034