Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

1010 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
15
level
mint-policy
Configures the global MiNT routing level
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
level 2 area-id <1-16777215>
Parameters
level 2 area-id <1-16777215>
Example
rfs7000-37FABE(config-mint-policy-global-default)#level 2 area-id 2000
rfs7000-37FABE(config-mint-policy-global-default)#show context
mint-policy global-default
level 2 area-id 2000
rfs7000-37FABE(config-mint-policy-global-default)#
end Ends and exits the current mode and moves to the PRIV EXEC mode page 234
exit Ends the current mode and moves to the previous mode page 387
help Displays the interactive help system page 387
revert Reverts changes to their last saved configuration page 394
service Invokes service commands to troubleshoot or debug
(config-if) instance
configurations
page 394
show Displays running system information page 429
write Writes information to memory or terminal page 425
TABLE 13 MiNT-Policy-Config Commands
Command Description Reference
level 2 Configures level 2 inter-site MiNT routing
area-id
<1-16777215>
Configures the routing area identifier
• <1-16777215> – Specify a value from 1 - 16777215.
The level 2 area ID is the global MiNT area identifier. This area identifier separates two overlapping MiNT
networks. Configure the level 2 area ID only if there are two MiNT networks sharing the same packet
broadcast domain.