Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 1003
53-1003098-01
14
proxy-arp
firewall-policy
Enables the generation of ARP responses on behalf of another device. This option is enabled by
default.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
proxy-arp
Parameters
None
Example
rfs7000-37FABE(config-fw-policy-test)#proxy-arp
rfs7000-37FABE(config-fw-policy-test)#
Related Commands:
stateful-packet-inspection-12
firewall-policy
Enables layer 2 firewall stateful packet inspection. This option is enabled by default.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
flow Configures firewall flows
ip Configures IP settings
ip-mac Defines actions based on the device IP MAC table
logging Configures firewall logging
proxy-arp Enables the generation of ARP responses on behalf of other devices
stateful-packet-inspection-12 Enables layer 2 stateful packet inspection
storm-control Configures storm control
virtual-defragmentation Configures the virtual defragmentation of packets at the firewall level
no Disables the generation of ARP responses on behalf of another device