Owner's manual

Message
vlan vlan-id interface portnum Bridge TC Event
(DOT1wTransition)
Explanation 802.1W recognized a topology change event in the bridge. The topology
change event is the forwarding action that started on a non-edge
Designated port or Root port.
Message Level Informational
Message
vlan vlan-id interface portnum STP state - state
(DOT1wTransition)
Explanation 802.1W changed the state of a port to a new state: forwarding, learning,
blocking. If the port changes to blocking, the bridge port is in discarding
state.
Message Level Informational
Message
vlan vlan-id New RootBridge mac-address RootPort
portnum (BpduRcvd)
Explanation 802.1W selected a new root bridge as a result of the BPDUs received on a
bridge port.
Message Level Informational
Message
vlan vlan-id New RootPort portnum (RootSelection)
Explanation 802.1W changed the port role to Root port, using the root selection
computation.
Message Level Informational
Message
ACL exceed max DMA L4 cam resource, using flow
based ACL instead
Explanation The port does not have enough Layer 4 CAM entries for the ACL.
To correct this condition, allocate more Layer 4 CAM entries. To allocate
more Layer 4 CAM entries, enter the following command at the CLI
configuration level for the interface:
ip access-group max-l4-cam num
Message Level Notification
Message
ACL insufficient L4 cam resource, using flow
based ACL instead
Syslog messages
342 FastIron Ethernet Switch Administration Guide
53-1003075-02