Owner's manual

Message
System: Temperature is over shutdown level,
system is going to be reset in num seconds
Explanation The chassis temperature has risen above shutdown level. The system will
be shut down in the amount of time indicated.
Message Level Alert
Message
Temperature degrees C degrees, warning level
warn-degrees C degrees, shutdown level shutdown-
degrees C degrees
Explanation Indicates an over temperature condition on the active module.
The degrees value indicates the temperature of the module.
The warn-degrees value is the warning threshold temperature configured
for the module.
The shutdown-degrees value is the shutdown temperature configured for
the module.
Message Level Alert
Message
Authentication shut down portnum due to DOS
attack
Explanation Denial of Service (DoS) attack protection was enabled for multi-device port
authentication on the specified portnum , and the per-second rate of
RADIUS authentication attempts for the port exceeded the configured limit.
The Brocade device considers this to be a DoS attack and disables the
port.
Message Level Critical
Message
BGP4: Not enough memory available to run BGP4
Explanation The device could not start the BGP4 routing protocol because there is not
enough memory available.
Message Level Debug
Message
DOT1X: Not enough memory
Explanation There is not enough system memory for 802.1X authentication to take
place. Contact Brocade Technical Support.
Message Level Debug
Syslog messages
324 FastIron Ethernet Switch Administration Guide
53-1003075-02