Owner's manual

To view the software and hardware details for the system, enter the show version command. The
following shows an example output.
device#show version
==========================================================================
Active Management CPU [Slot-9]:
SW: Version 04.3.00b17T3e3 Copyright (c) 1996-2008 Brocade Communications, Inc.,
Inc.
Compiled on Sep 25 2008 at 04:09:20 labeled as SXR04300b17
(4031365 bytes) from Secondary sxr04300b17.bin
BootROM: Version 04.0.00T3e5 (FEv2)
HW: ANR-Chassis FastIron SX 1600-PREM (PROM-TYPE SX-FIL3U)
Serial #: TExxxxxxxx
==========================================================================
SL 3: SX-FI424C 24-port Gig Copper
Serial #: CYxxxxxxxxx
P-ASIC 4: type 00D1, rev D2 subrev 00
P-ASIC 5: type 00D1, rev D2 subrev 00
==========================================================================
SL 9: SX-FI8GMR4 8-port Management
Serial #: CHxxxxxxxx
P-ASIC 16: type 00D1, rev D2 subrev 00
==========================================================================
SL 14: SX-FI42XGW 2-port 10G LAN/WAN
Serial #: Invalid
P-ASIC 26: type 01D1, rev 00 subrev 00
P-ASIC 27: type 01D1, rev 00 subrev 00
==========================================================================
Active Management Module:
660 MHz Power PC processor 8541 (version 32/0020) 66 MHz bus
512 KB boot flash memory
16384 KB code flash memory
512 MB DRAM
The system uptime is 2 minutes 13 seconds
The system : started=warm start reloaded=by "reload"
*** NOT FOR PRODUCTION ***
*** AUTO SHUTDOWN IS OFF. PLEASE ACTIVATE WITH auto-shutdown ***
The following hardware details are listed in the output of the show version command:
• Chassis type
• PROM type (if applicable)
• Chassis serial number
• Management and interface module serial numbers and ASIC types
For a description of the software details in the output of the show version command, refer to the
section Viewing system information.
Syntax: show version
Viewing configuration information
You can view a variety of configuration details and statistics with the show option. The show option
provides a convenient way to check configuration changes before saving them to flash.
The show options available will vary for Layer 2 Switches and Layer 3 Switches and by configuration
level.
To determine the available show commands for the system or a specific level of the CLI, enter the
following command.
device#show ?
Syntax: show option
You also can enter "show" at the command prompt, then press the TAB key.
Viewing configuration information
230 FastIron Ethernet Switch Administration Guide
53-1003075-02