Administrator's Guide Supporting RSA Data Protection Manager (DPM) Environments (Supporting Fabric OS v7.2.0) Owner's manual

Table Of Contents
Fabric OS Encryption Administrator’s Guide (DPM) 37
53-1002922-01
Creating an encryption group
2
4. From the Configure Switch Encryption welcome screen, click Next to begin.
The Designate Switch Membership dialog box displays. (Refer to Figure 19.) The dialog box
contains the following options:
Create a new encryption group containing just the switch: Creates an encryption group for
the selected switch
Add this switch to an existing encryption group: Adds the selected switch to an encryption
group that already exists
FIGURE 19 Designate Switch Membership dialog box
5. For this procedure, verify that Create a new encryption group containing just this switch is
selected, then click Next.
NOTE
If you are adding a switch to an encryption, refer to Adding a switch to an encryption group” on
page 46.
The Create a New Encryption Group dialog box displays. (Refer to Figure 20.)