Administrator's Guide Supporting NetApp Lifetime Key Manager (LKM) and KeySecure Storage Secure Key Manager (SSKM) Environments (Supporting Fabric OS v7.2.0) User Manual

90 Fabric OS Encryption Administrator’s Guide (LKM/SSKM)
53-1002925-01
Rekeying all disk LUNs manually
2
• Re-key State: The state of a manual LUN rekeying operation. Options are:
- Read Phase
- Write Phase
- Pending
- Disabled
• Block Size: The block size used on the LUN.
• Number of Blocks: The number of blocks written.
• Current LBA: The Logical Block Address (LBA) of the block that is currently being written.
• Re-key Completion: The status of the LUN rekeying operation’s progress.
Viewing the progress of manual rekey operations
To monitor the progress of manual rekey operations, complete these steps:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 6 on page 14.)
1. Select an encryption group from the Encryption Center Devices table, then select Group >
Re-Key Sessions from the menu task bar.
The Re-Key Sessions Status dialog box displays, which enables you to check on the status of
each LUN that is being rekeyed within an encryption group. (Refer to Figure 70.)
FIGURE 70 Re-Key Sessions Status dialog box
The Re-Key Sessions Status dialog box contains the following information:
• LUN #: The LUN number.
• LUN Serial #: The LUN serial number.
• Re-Key Session #: The number assigned to the rekeying session.
• Percent Complete: The percentage of completion of the rekeying session.