Administrator's Guide Supporting Key Management Interoperability Protocol (KMIP) Key-Compliant Environments (Supporting Fabric OS v7.1.0) User guide

Fabric OS Encryption Administrator’s Guide (KMIP) 119
53-1002747-02
Rekeying all disk LUNs manually
2
Viewing the progress of manual rekey operations
To monitor the progress of manual rekey operations, complete these steps:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box (Refer to Figure 6 on page 14).
2. Select an encryption group from the Encryption Center Devices table, then select Group >
Re-Key Sessions from the menu task bar.
The Re-Key Sessions Status dialog box displays, which enables you to check on the status of
each LUN that is being rekeyed within an encryption group (Figure 101).
FIGURE 101 Re-Key Sessions Status dialog box
The dialog box contains the following information:
• LUN #: The LUN number.
• LUN Serial #: The LUN serial number.
• Re-Key Session #: The number assigned to the rekeying session.
• Percent Complete: The percentage of completion of the rekeying session.
• Re-Key State: Options are:
• Re-Key Setup
• LUN Prep
• LUN Clean-up
• Key Update
• Read Phase
• Write Phase
• HA Sync Phase
• Re-Key Role: Options are:
• Primary/Active
• Backup/Active
• Block Size: The block size used on the LUN.
• Container Name: The CryptoTarget container name.
• Host Port WWN: The WWN of the host port that is being used for the write operation.