Administrator's Guide Supporting HP Secure Key Manager (SKM) and HP Enterprise Secure Key Manager (ESKM) Environments (Supporting Fabric OS v7.2.0) Instruction Manual

Fabric OS Encryption Administrator’s Guide (SKM/ESKM) 61
53-1002923-01
Configuring encryption storage targets
2
5. Confirmation
6. Configuration Status
7. Important Instructions
Adding an encryption target
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 1 on page 14.)
2. Select a group, switch, or engine from the Encryption Center Devices table to which to add the
target, then select Group/Switch/Engine > Targets from the menu task bar.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays. (Refer to Figure 34.)
FIGURE 34 Encryption Targets dialog box
3. Click Add.
The Configure Storage Encryption welcome screen displays. (Refer to Figure 35.)