Reference (Supporting Fabric OS v7.3.0) Owner manual

Fabric OS Command Reference 209
53-1003131-01
cryptoCfg
2
- Tape policy type: pool-based or LUN-based
- Key life: key lifespan in days
- Volume/pool label
- LUN state: Refer to the Fabric OS Encryption Administrator's Guide.
- Encryption algorithm: AES256 -XTS (disk), AES256-CCM (tape), or none
- Compression algorithm
- Key ID state: available or not available
- Key ID: numeric identifier if available
- New LUN: Yes or No
- Replication LUN type: Primary or Mirror
If the LUN is a disk and the LUN is enabled for auto rekey, the following additional information is
displayed below the Key ID. Refer to the example section for an illustration.
- Key creation time: date and time
- Key life: remaining time (in days) until the key expires
- Rekey status: 0 = rekey in progress, 1 = no rekey in progress
- Key expiration time: date and time
- Time remaining to Auto Rekey: Displays key life for LUNs that
- are currently being rekeyed and after the rekey is complete.
- The remaining Key life period is displayed in the following format: num_yrs, num_months,
num_days, num_minutes.
When used with -cfg the --show -LUN command displays LUN configuration information:
• EE node: node WWN
• EE slot: slot number
• Target: target port WWN and node NWWN
• VT: virtual target port WWN and node WWN
• Number of hosts: numeric value
• Configuration status: committed or defined
• For each host:
- Host port WWN and node WWN
- Virtual initiator port WWN and node WWN
- Virtual initiator PID
• Number of LUNs
• For each LUN:
- LUN number: numeric identifier
- LUN type: disk, tape drive, tape medium changer, tape attached medium changer,
offline/unknown, or unsupported/other
- LUN status: numeric value
- Encryption mode: encrypt or cleartext
- Encryption format: native or DF compatible
- Tape policy type: pool-based or LUN-based
- Encrypt existing data: disabled or enabled
- Rekey: disabled or enabled
- Key ID state: Read, Write, or Key ID not applicable
- Key life (in days): numeric value