Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide 907
53-1002651-02
42
Filtering IP Addresses for Management Access
Displaying the ARP Inspection Log
Use the Security > ARP Inspection (Show Information - Show Log) page to show information about
entries stored in the log, including the associated VLAN, port, and address components.
CLI References
“show ip arp inspection log” on page 231
Parameters
These parameters are displayed:
Interface
To display the ARP Inspection log:
1. Click Security, ARP Inspection.
2. Select Show Information from the Step list.
3. Select Show Log from the Action list.
FIGURE 222 Displaying the ARP Inspection Log
Filtering IP Addresses for Management Access
Use the Security > IP Filter page to create a list of up to 15 IP addresses or IP address groups that
are allowed management access to the switch through the web interface, SNMP, or Telnet.
CLI References
“Management IP Filter” on page 186
Command Usage
The management interfaces are open to all IP addresses by default. Once you add an entry to
a filter list, access to that interface is restricted to the specified addresses.
TABLE 170 ARP Inspection Log
Parameter Description
VLAN ID The VLAN where this packet was seen.
Port The port where this packet was seen.
Src. IP Address The source IP address in the packet.
Dst. IP Address The destination IP address in the packet.
Src. MAC Address The source MAC address in the packet.
Dst. MAC Address The destination MAC address in the packet.