Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide 839
53-1002651-02
40
Attaching a Policy Map to a Port
Attaching a Policy Map to a Port
Use the Traffic > DiffServ (Configure Interface) page to bind a policy map to a port.
CLI References
• “Quality of Service Commands” on page 427
Command Usage
First define a class map, define a policy map, and then bind the service policy to the required
interface.
Parameters
These parameters are displayed:
• Port – Specifies a port.
• Ingress – Applies the selected rule to ingress traffic.
• Egress – Applies the selected rule to egress traffic.
Interface
To bind a policy map to a port:
1. Click Traffic, DiffServ.
2. Select Configure Interface from the Step list.
3. Check the box under the Ingress field to enable a policy map for a port.
4. Select a policy map from the scroll-down box.
5. Click Apply.
FIGURE 162 Attaching a Policy Map to a Port