Configuration Guide (Supporting R2.2.0.0) Owner's manual

772 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
35
Configuring IP Subnet VLANs
Priority – The priority assigned to untagged ingress traffic. (Range: 0-7, where 7 is the highest
priority; Default: 0)
Interface
To map an IP subnet to a VLAN:
1. Click VLAN, IP Subnet.
2. Select Configure IP Subnet from the Step list.
3. Select Add from the Action list.
4. Enter an address in the IP Address field.
5. Enter a mask in the Subnet Mask field.
6. Enter the identifier in the VLAN field. Note that the specified VLAN need not already be
configured.
7. Enter a value to assign to untagged frames in the Priority field.
8. Click Apply.
FIGURE 100 Configuring IP Subnet VLANs
To show the configured IP subnet VLANs:
1. Click VLAN, IP Subnet.
2. Select Configure IP Subnet from the Step list.
3. Select Show from the Action list.
FIGURE 101 Showing IP Subnet VLANs