Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide 719
53-1002651-02
34
Port Configuration
Interface
To display identifying information and functional parameters for optical transceivers:
1. Click Interface, Port, Transceiver.
2. Select Show Information from the Action list.
3. Select a port from the scroll-down list.
FIGURE 49 Displaying Transceiver Data
Configuring Transceiver Thresholds
Use the Interface > Port > Transceiver (Configure DDM Thresholds) page to configure thresholds for
alarm and warning messages for optical transceivers which support Digital Diagnostic Monitoring
(DDM).
CLI References
• “transceiver-threshold current” on page 264
• “transceiver-threshold rx-power” on page 265
• “transceiver-threshold temperature” on page 266
• “transceiver-threshold tx-power” on page 267
• “transceiver-threshold voltage” on page 268