Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide 683
53-1002651-02
33
Managing System Files
FIGURE 16 Setting Start-Up Files
To start using the new firmware or configuration settings, reboot the system via the System > Reset
menu.
Showing System Files
Use the System > File (Show) page to show the files in the system directory, or to delete a file.
NOTE
Files designated for start-up, and the Factory_Default_Config.cfg file, cannot be deleted.
CLI References
• “dir” on page 70
• “delete” on page 70
Interface
To show the system files:
1. Click System, then File.
2. Select Show from the Action list.
3. To delete a file, mark it in the File List and click Delete.
FIGURE 17 Displaying System Files