Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide 669
53-1002651-02
32
Navigating the Web Browser Interface
ERPS Ethernet Ring Protection Switching 982
Configure Global
Activates ERPS globally 984
Configure Domain
985
Add
Creates an ERPS ring 985
Show
Shows list of configured ERPS rings, status, and settings 985
Configure Details
Configures ring parameters 985
CFM Connectivity Fault Management 992
Configure Global
Configures global settings, including administrative status, cross-check
start delay, link trace, and SNMP traps
995
Configure Interface
Configures administrative status on an interface 998
Configure MD
Configure Maintenance Domains 999
Add
Defines a portion of the network for which connectivity faults can
be managed, identified by an MD index, maintenance level, and the MIP
creation method
999
Configure Details
Configures the archive hold time and fault notification settings 999
Show
Shows list of configured maintenance domains 999
Configure MA
Configure Maintenance Associations 1003
Add
Defines a unique CFM service instance, identified by its parent MD, the
MA index, the VLAN assigned to the MA, and the MIP creation method
1003
Configure Details
Configures detailed settings, including continuity check status and
interval level, cross-check status, and alarm indication signal parameters
1003
Show
Shows list of configured maintenance associations 1003
Configure MEP
Configures Maintenance End Points 1007
Add
Configures MEPs at the domain boundary to provide management access
for each maintenance association
1007
Show
Shows list of configured maintenance end points 1007
Configure Remote MEP
Configures Remote Maintenance End Points 1008
Add
Configures a static list of remote MEPs for comparison against
the MEPs learned through continuity check messages
1008
Show
Shows list of configured remote maintenance end points 1008
Configure Periodic Delay Measure
Configures periodic transmission of delay-measure messages 1010
Add Group
Configures a delay-measure attribute group 1010
Show Group
Shows delay-measure attribute groups 1010
Configure
Transmits perioic delay-measure messages 1010
Configure Periodic Loss Measure
Configures periodic transmission of loss-measure messages 1014
Add Single-Ended LM Group
Configures a single-ended loss-measure attribute group 1014
Show Single-Ended LM Group
Shows single-ended loss-measure attribute groups 1014
Configure Single-Ended LM
Transmits periodic single-ended loss-measure messages 1014
TABLE 153 Switch Main Menu (Continued)
Menu Description Page