Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide 661
53-1002651-02
32
Navigating the Web Browser Interface
Modify
Configures group name and administrative status 752
Edit Member by VLAN
Specifies VLAN attributes per VLAN 754
Edit Member by Interface
Specifies VLAN attributes per interface 754
Edit Member by Interface Range
Specifies VLAN attributes per interface range 754
Dynamic
Configure General
Enables GVRP VLAN registration protocol globally 758
Configure Interface
Configures GVRP status and timers per interface 758
Show Dynamic VLAN
758
Show VLAN
Shows the VLANs this switch has joined through GVRP 758
Show VLAN Member
Shows the interfaces assigned to a VLAN through GVRP 758
Tunnel IEEE 802.1Q (QinQ) Tunneling 760
Configure Global
Sets tunnel mode for the switch 763
Configure Service
Sets a CVLAN to SPVLAN mapping entry 764
Configure Interface
Sets the tunnel mode for any participating interface 766
Protocol 767
Configure Protocol
768
Add
Creates a protocol group, specifying supported protocols 768
Show
Shows configured protocol groups 768
Configure Interface
769
Add
Maps a protocol group to a VLAN 769
Show
Shows the protocol groups mapped to each VLAN 769
IP Subnet 771
Configure Subnet VLAN
Add
Maps IP subnet traffic to a VLAN 771
Show
Shows IP subnet to VLAN mapping 771
Configure Interface
Add
Maps IP subnet traffic to a port/trunk 773
Show
Shows IP subnet to port/trunk mapping 773
MAC-Based 774
Add
Maps traffic with specified source MAC address to a VLAN 774
Show
Shows source MAC address to VLAN mapping 774
Mirror 775
Add
Mirrors traffic from one or more source VLANs to a target port 775
Show
Shows mirror list 775
Translation 777
Add
Maps VLAN IDs between the customer and service provider 777
TABLE 153 Switch Main Menu (Continued)
Menu Description Page