Configuration Guide (Supporting R2.2.0.0) Owner's manual

658 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
32
Navigating the Web Browser Interface
Main Menu
Using the onboard web agent, you can define system parameters, manage and control the switch,
and all its ports, or monitor network conditions. The following table briefly describes the selections
available from this program.
TABLE 153 Switch Main Menu
Menu Description Page
System
General Provides basic system description, including contact information 675
Switch Shows the number of ports, hardware version, power status, and
firmware version numbers
676
Capability Enables support for jumbo frames;
shows the bridge extension parameters
677,
678
File 679
Copy
Allows the transfer and copying files 679
Set Startup
Sets the startup file 682
Show
Shows the files stored in flash memory; allows deletion of files 683
Automatic Operation Code Upgrade
Automatically upgrades operation code if a newer version is
found on the server
684
Time 687
Configure General
Manual
Manually sets the current time 687
SNTP
Configures SNTP polling interval 688
Configure Time Server
Configures a list of SNTP servers 689
Configure Time Zone
Sets the local time zone for the system clock 690
Summer Time
Configures summer time settings 691
Date
Configures summer time on a one-time basis 691
Predefined
Configures summer time using predefined configurations for several
major regions of the world
691
Recurring
Configures summer time on a recurring basis 691
Console Sets console port connection parameters 693
Telnet Sets Telnet connection parameters 694
CPU Utilization Displays information on CPU utilization 696
Memory Status Shows memory utilization parameters 696
Reset Restarts the switch immediately, at a specified time, after a specified
delay, or at a periodic interval
697
Interface 701
Port 701
General
Configure by Port List
Configures connection settings per port 701