Configuration Guide (Supporting R2.2.0.0) Owner's manual

598 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
29
IPv4 Interface
Command Mode
Global Configuration
Command Usage
• Static routes can also be defined using the ip route command to ensure that traffic to the
designated address or subnet passes through a preferred gateway.
• A default gateway can only be successfully set when a network interface that directly connects
to the gateway has been configured on the switch.
• A gateway must be defined if the management station is located in a different IP segment.
• Use the show ip route command to display the default gateway.
Example
The following example defines a default gateway for this device:
Console(config)#ip default-gateway 10.1.1.254
Console(config)#
Related Commands
“ip address” on page 596
“ip route” on page 629
“show ip route” on page 630
“ipv6 default-gateway” on page 606
show ip interface
This command displays the settings of an IPv4 interface.
Command Mode
Privileged Exec
Example
Console#show ip interface
VLAN 1 is Administrative Up - Link Up
Address is 00-E0-0C-00-00-FD
Index: 1001, MTU: 1500
Address Mode is DHCP
IP Address: 192.168.0.2 Mask: 255.255.255.0
Craft interface is Administrative Up
IP Address: 192.168.1.2 Mask: 255.255.255.0
Console#
Related Commands
“ip address” on page 596
“show ipv6 interface” on page 614
show ip traffic
This command displays statistics for IP, ICMP, UDP, TCP and ARP protocols.
Command Mode
Privileged Exec