Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide 571

53-1002651-02

OAM Commands

• Dying gasp events are caused by an unrecoverable failure, such as a power failure or device

reset.

NOTE

When system power fails, the switch will always send a dying gasp trap message prior to power

down.

Example

Console(config)#interface ethernet 1/1

Console(config-if)#efm oam critical-link-event dying-gasp

Console(config-if)#

efm oam link-monitor frame

This command enables reporting of errored frame link events. Use the no form to disable this

function.

Syntax

[no] efm oam link-monitor frame

Default Setting

Enabled

Command Mode

Interface Configuration

Command Usage

• An errored frame is a frame in which one or more bits are errored.

• If this feature is enabled and an errored frame link event occurs, the local OAM entity (this

switch) sends an Event Notification OAMPDU.

Example

Console(config)#interface ethernet 1/1

Console(config-if)#efm oam link-monitor frame

Console(config-if)#

efm oam link-monitor frame threshold

This command sets the threshold for errored frame link events. Use the no form to restore the

default setting.

Syntax

[no] efm oam link-monitor frame threshold count

count - The threshold for errored frame link events. (Range: 1-65535)

Default Setting