Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide 529

53-1002651-02

CFM Commands

ethernet cfm port-enable

This command enables CFM processing on an interface. Use the no form to disable CFM

processing on an interface.

Syntax

[no] ethernet cfm port-enable

Default Setting

Enabled

Command Mode

Interface Configuration (Ethernet, Port Channel)

Command Usage

• An interface must be enabled before a MEP can be created with the ethernet cfm mep

command.

• If a MEP has been configured on an interface with the ethernet cfm mep command, it must

first be deleted before CFM can be disabled on that interface.

• When CFM is disabled, hardware resources previously used for CFM processing on that

interface are released, and all CFM frames entering that interface are forwarded as normal

data traffic.

Example

This example enables CFM on port 1.

Console(config)#interface ethernet 1/1

Console(config-if)#ethernet cfm port-enable

Console(config-if)#

clear ethernet cfm ais mpid

This command clears AIS defect information for the specified MEP.

Syntax

clear ethernet cfm ais mpid mpid md domain-name ma ma-name

mpid – Maintenance end point identifier. (Range: 1-8191)

domain-name – Domain name. (Range: 1-43 alphanumeric characters)

ma-name – Maintenance association name. (Range: 1-43 alphanumeric characters,

maximum length is 44 minus the length of the domain name)

Default Setting

None

Command Mode

Privileged Exec