Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide 527
53-1002651-02
25
CFM Commands
Before removing an MA, first remove all the MEPs configured for it (see the mep crosscheck
mpid command).
If the MIP creation method is not defined by this command, the creation method defined by the
ethernet cfm domain command is applied to this MA. For a detailed description of the MIP
types, refer to the Command Usage section under the ethernet cfm domain command.
Example
This example creates a maintenance association, binds it to VLAN 1, and allows MIPs to be created
within this MA using the default method.
Console(config)#ethernet cfm domain index 1 name voip level 3
Console(config-ether-cfm)#ma index 1 name rd vlan 1 mip-creation default
Console(config-ether-cfm)#
ma index name-format
This command specifies the name format for the maintenance association as IEEE 802.1ag
character based, or ITU-T SG13/SG15 Y.1731 defined ICC-based format. Use the no form to restore
the default setting.
Syntax
ma index index name-format {character-string | icc-based}
no ma index index name-format
index – MA identifier. (Range: 1-2147483647)
character-stringIEEE 802.1ag defined character string format. This is an IETF RFC 2579
DisplayString.
icc-basedITU-T SG13/SG15 Y.1731 defined ICC based format.
Default Setting
character-string
Command Mode
CFM Domain Configuration
Example
This example specifies the name format as character string.
Console(config)#ethernet cfm domain index 1 name voip level 3
Console(config-ether-cfm)#ma index 1 name-format character-string
Console(config-ether-cfm)#