Configuration Guide (Supporting R2.2.0.0) Owner's manual
Brocade 6910 Ethernet Access Switch Configuration Guide 519
53-1002651-02
25
CFM Commands
Link Trace Operations
ethernet cfm linktrace
cache
Enables caching of CFM data learned through link trace messages GC
ethernet cfm linktrace
cache hold-time
Sets the hold time for CFM link trace cache entries GC
ethernet cfm linktrace
cache size
Sets the maximum size for the link trace cache GC
ethernet cfm linktrace Sends CFM link trace messages to the MAC address for a MEP PE
clear ethernet cfm
linktrace-cache
Clears link trace messages logged on this device PE
show ethernet cfm
linktrace-cache
Displays the contents of the link trace cache PE
Loopback Operations
ethernet cfm loopback Sends CFM loopback messages to a MAC address for a MEP or MIP PE
Fault Generator Operations
mep fault-notify alarm-time Sets
the time a defect must exist before a fault alarm is issued
CFM
mep fault-notify
lowest-priority
Sets the lowest priority defect that is allowed to generate a fault alarm CFM
mep fault-notify reset-time Configures the time after a fault alarm has been issued, and no defect
exists, before another fault alarm can be issued
CFM
show ethernet cfm
fault-notify-generator
Displays configuration settings for the fault notification generator PE
Delay Measure Operations
ethernet cfm delay-measure
binding
Binds periodic delay-measure settings to a specified local MEP GC
ethernet cfm delay-measure
destination
Sets the destination MEP or MAC address for periodically transmitted
delay-measure messages
GC
ethernet cfm delay-measure
enable
Enables periodic transmission of delay-measure messages GC
ethernet cfm delay-measure
group
Sets attributes for periodically transmitted delay-measure messages,
including transmission cycle, duration, interval, and timeout
GC
ethernet cfm delay-measure
threshold
Sets the threshold for frame delay measurements at which an SNMP
trap is sent and an entry recorded in the system log
GC
snmp-server enable traps
ethernet cfm delay-measure
threshold
Enables SNMP trap generation for delay-measure transmissions at or
above a configured threshold
GC
ethernet cfm delay-measure
one-way
Sends on-demand delay-measure information to a specified MEP,
stamped with the time of transmission
PE
ethernet cfm delay-measure
two-way
Sends on-demand delay-measure requests to a specified MEP, which
subsequently returns a time-stamped delay-measure reply
PE
show ethernet cfm
delay-measure two-way
Displays frame delay and frame delay variation of on-demand two-way
delay-measure tests
PE
TABLE 124 CFM Commands (Continued)
Command Function Mode