Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide li
53-1002651-02
Summary of enhancements for Brocade R2.1.0.4
The following table describes the features introduced in R2.1.0.4.
Summary of enhancements for Brocade R2.0.2.10
The following table describes the features introduced in R2.0.2.10.
Added display of DDM
thresholds
Added display of DDM thresholds. See “show interfaces transceiver” on
page 277 and “Configuring Transceiver Thresholds” on page 719.
Added configuration of DDM
thresholds
Added web page for configuring DDM thresholds. See “Configuring Transceiver
Thresholds on page 719.
Added debug commands Added debug commands for reporting errors to Brocade for technical support.
See “Debug Commands” on page 633.
Enhancement Description
Enhancement Description
Supports SFTP file transfer Added information about using SFTP for file transfer. See “copy” on page 67 and
“Copying Files via FTP/SFTP/TFTP or HTTP” on page 679.
Supports additional privacy
encryption methods for
SNMPv3
Added AES128, AES192 and AES256 privacy encryption methods for SNMPv3.
Refer to “snmp-server user” on page 115, “Configuring Local SNMPv3 Users” on
page 962, and “Configuring Remote SNMPv3 Users” on page 963.
Supports configuration of
LACP timeout
The LACP timeout the switch waits for the next LACPDU can be configured to a
long or short interval. Refer to “lacp timeout” on page 292 and “Configuring a
Dynamic Trunk” on page 728.
Enhancement Description
Supports adjusting the system
clock for summer time
Added configuration pages and CLI commands for adjusting the system clock for
the summer time offset. See the relevant commands starting at “clock
summer-time (date) on page 96 and “Configuring Summer Time” on page 691.
SNMP trap manager can be
configured with IPv4 or IPv6
address
SNMP trap managers can now be configured with IPv4 or IPv6 address. Refer to
“snmp-server host” on page 111 and “Specifying Trap Managers on page 965.
IP address for a Layer 3
interface can be configured
with a network prefix
The IP address for a Layer 3 interface can be configured with a network prefix in
the CLI. Refer to “ip address” on page 596
Action and Shutdown Interval
were added to the web page
for Loopback Detection
Action and Shutdown Interval were added to the web page for Loopback
Detection. Refer to “Configuring Loopback Detection” on page 787.