Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide 377
53-1002651-02
20
Configuring VLAN Interfaces
Example
Console(config)#vlan database
Console(config-vlan)#no vlan 1 mac-learning
Console(config-vlan)#
show mac-learning
This command shows the status of MAC address learning for the specified VLAN.
Syntax
show mac-learning vlan vlan-id
vlan-id - ID of the configured VLAN. (Range: 1-4093)
Default Setting
Shows all VLANs.
Command Mode
Normal Exec, Privileged Exec
Example
The following example show the status of MAC address learning for VLAN 1:
Console#show mac-learning vlan 1
VLAN Learning Status
---- ---------------
1 Enabled
Console#
Configuring VLAN Interfaces
TABLE 85 Commands for Configuring VLAN Interfaces
Command Function Mode
interface vlan Enters interface configuration mode for a specified VLAN IC
switchport acceptable-frame-types Configures frame types to be accepted by an interface IC
switchport allowed vlan Configures the VLANs associated with an interface IC
switchport forbidden vlan Configures forbidden VLANs for an interface IC
switchport gvrp Enables GVRP for an interface IC
switchport ingress-filtering Enables ingress filtering on an interface IC
switchport mode Configures VLAN membership mode for an interface IC
switchport native vlan Configures the PVID (native VLAN) of an interface IC
switchport priority default Sets a port priority for incoming untagged frames IC
vlan-trunking Allows unknown VLANs to cross the switch IC