Configuration Guide (Supporting R2.2.0.0) Owner's manual
318 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
16
Automatic Traffic Control Commands
snmp-server enable port-traps atc broadcast-control-apply
This command sends a trap when broadcast traffic exceeds the upper threshold for automatic
storm control and the apply timer expires. Use the no form to disable this trap.
Syntax
[no] snmp-server enable port-traps atc broadcast-control-apply
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-control-apply
Console(config-if)#
Related Commands
“auto-traffic-control alarm-fire-threshold” on page 315
“auto-traffic-control apply-timer” on page 311
snmp-server enable port-traps atc broadcast-control-release
This command sends a trap when broadcast traffic falls beneath the lower threshold after a storm
control response has been triggered and the release timer expires. Use the no form to disable this
trap.
Syntax
[no] snmp-server enable port-traps atc
broadcast-control-release
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-control-release
Console(config-if)#
Related Commands
“auto-traffic-control alarm-clear-threshold” on page 314
“auto-traffic-control action” on page 313
“auto-traffic-control release-timer” on page 312