Configuration Guide (Supporting R2.2.0.0) Owner's manual

198 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
10
Network Access (MAC Address Authentication)
Default Setting
Disabled
Command Mode
Interface Configuration
Command Usage
The VLAN to be used as the guest VLAN must be defined and set as active (See the vlan
database command).
When used with 802.1X authentication, the intrusion-action must be set for “guest-vlan” to be
effective (see the dot1x intrusion-action command).
Example
Console(config)#interface ethernet 1/1
Console(config-if)#network-access guest-vlan 25
Console(config-if)#
network-access link-detection
Use this command to enable link detection for the selected port. Use the no form of this command
to restore the default.
Syntax
[no] network-access link-detection
Default Setting
Disabled
Command Mode
Interface Configuration
Example
Console(config)#interface ethernet 1/1
Console(config-if)#network-access link-detection
Console(config-if)#
network-access link-detection link-down
Use this command to detect link-down events. When detected, the switch can shut down the port,
send an SNMP trap, or both. Use the no form of this command to disable this feature.
Syntax
network-access link-detection link-down action [shutdown | trap | trap-and-shutdown]
no network-access link-detection
action - Response to take when port security is violated.
shutdown - Disable port only.
trap - Issue SNMP trap message only.
trap-and-shutdown - Issue SNMP trap message and disable the port.