Configuration Guide (Supporting R2.2.0.0) Owner's manual

70 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
5
File Management
User [Anonymous]:
Password:
Choose file type:
1. config: 2. opcode: 3. loader: 1
Source file name: startup2.cfg
Destination file name: startup2.cfg
Flash programming started.
Flash programming completed.
Success.
Console#
delete
This command deletes a file or image.
Syntax
delete filename
filename - Name of configuration file or code image.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• If the file type is used for system startup, then this file cannot be deleted.
• “Factory_Default_Config.cfg” cannot be deleted.
Example
This example shows how to delete the test2.cfg configuration file from flash memory.
Console#delete test2.cfg
Console#
Related Commands
“dir” on page 70
“delete public-key” on page 169
dir
This command displays a list of files in flash memory.
Syntax
dir {boot-rom: | config: | opcode:} [filename]}
boot-rom
- Boot ROM (or diagnostic) image file.
config - Switch configuration file.
opcode - Run-time operation code image file.
filename - Name of configuration file or code image. If this file exists but contains errors,
information on this file cannot be shown.