Configuration Guide (Supporting R2.2.0.0) Owner's manual

1110 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
47
Filtering and Throttling IGMP Groups
Enabling IGMP Filtering and Throttling
Use the Multicast > IGMP Snooping > Filter (Configure General) page to enable IGMP filtering and
throttling globally on the switch.
CLI References
• “ip igmp filter (Global Configuration)” on page 464
Parameters
These parameters are displayed:
• IGMP Filter Status – Enables IGMP filtering and throttling globally for the switch.
(Default: Disabled)
Interface
To enable IGMP filtering and throttling on the switch:
1. Click Multicast, IGMP Snooping, Filter.
2. Select Configure General from the Step list.
3. Enable IGMP Filter Status.
4. Click Apply.
FIGURE 383 Enabling IGMP Filtering and Throttling
Configuring IGMP Filter Profiles
Use the Multicast > IGMP Snooping > Filter (Configure Profile – Add) page to create an IGMP profile
and set its access mode. Then use the (Add Multicast Group Range) page to configure the
multicast groups to filter.
CLI References
• “IGMP Filtering and Throttling” on page 464
Command Usage
Specify a range of multicast groups by entering a start and end IP address; or specify a single
multicast group by entering the same IP address for the start and end of the range.
Parameters
These parameters are displayed:
Add
• Profile ID – Creates an IGMP profile. (Range: 1-4294967295)