Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide 1083
53-1002651-02
46
Domain Name Service
3. Enter one domain name at a time.
4. Click Apply.
FIGURE 359 Configuring a List of Domain Names for DNS
To show the list domain names:
1. Click IP Service, DNS.
2. Select Show Domain Names from the Action list.
FIGURE 360 Showing the List of Domain Names for DNS
Configuring a List of Name Servers
Use the IP Service > DNS - General (Add Name Server) page to configure a list of name servers to
be tried in sequential order.
CLI References
• “ip name-server” on page 582
• “show dns” on page 585
Command Usage
• To enable DNS service on this switch, configure one or more name servers, and enable domain
lookup status (see “Configuring General DNS Service Parameters” on page 1081).
• When more than one name server is specified, the servers are queried in the specified
sequence until a response is received, or the end of the list is reached with no response.
• If all name servers are deleted, DNS will automatically be disabled. This is done by disabling
the domain lookup status.