Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide 1073
53-1002651-02
44
Address Resolution Protocol
FIGURE 350 Displaying Static ARP Entries
Displaying ARP Entries
Use the IP > ARP (Show Information) page to display dynamic entries in the ARP cache . The ARP
cache contains entries for local interfaces, including subnet, host, and broadcast addresses. These
entries are dynamically learned through replies to broadcast
messages.
CLI References
• “show arp” on page 604
• “clear arp-cache” on page 604
Command Usage
Static entries are only displayed for VLANs that are up. In other words, static entries are only
displayed when configured for the IP subnet of a existing VLAN, and that VLAN is linked up.
Interface
To display all dynamic entries in the ARP cache:
1. Click IP, ARP.
2. Select Show Information from the Step List.
3. Click Dynamic Address.
FIGURE 351 Displaying ARP Entries
To display all local entries in the ARP cache:
1. Click IP, ARP.
2. Select Show Information from the Step List.
3. Click Other Address.