Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide 1045
53-1002651-02
43
OAM Configuration
• Packets Transmitted – The number of loop back frames transmitted during the last
loopback test on this interface.
• Packets Received – The number of loop back frames received during the last loopback
test on this interface.
• Loss Rate – The percentage of packets for which there was no response.
Interface
To initiate a loop back test to the peer device attached to the selected port:
1. Click Administration, OAM, Remote Loop Back.
2. Select Remote Loopback Test from the Action list.
3. Select the port on which to initiate remote loop back testing, enable the Loop Back Mode
attribute, and click Apply.
4. Set the number of packets to send and the packet size, and then click Test.
FIGURE 331 Running a Remote Loop Back Test
Terminating Loopback The local OAM client is in the process of terminating the remote loopback.
Local Loopback The remote OAM client has put the local OAM entity in loopback mode.
Unknown This status may be returned if the OAM loopback is in a transition state but
should not persist.
TABLE 181 Remote Loopback Status (Continued)
State Description