Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide 1037
53-1002651-02
43
Connectivity Fault Management
FIGURE 324 Showing Continuity Check Errors
Displaying Two-Way Delay-Measure Results
Use the Administration > CFM > Show Information (Show Two-Way Delay-Measure Results) page to
display on-demand delay-measure requests logged on this device.
CLI References
• “show ethernet cfm delay-measure two-way” on page 561
Parameters
These parameters are displayed:
• Transmit DMM Time – The message transmission time.
• Delay Time – The delay between message transmission and reception.
• Delay Variation – The variation in delay time.
Interface
To show on-demand delay-measure requests:
1. Click Administration, CFM.
2. Select Show Information from the Step list.
3. Select Show Two-Way Delay-Measure Results from the Action list.
FIGURE 325 Showing Two-Way Delay-Measure Results