Configuration Guide (Supporting R2.2.0.0) Owner's manual

1016 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
43
Connectivity Fault Management
Show Single-Ended LM Group
The parameters on this page are the same as described for the Add Single-Ended LM Group page,
except for the followin item.
• MEP Bind – Indicates whether or not an attribute group has been bound to a local MEP.
Configure Single-Ended LM
• MD Index – Domain index. (Range: 1-65535)
• MA Index – MA identifier. (Range: 1-2147483647)
• MEP ID – Maintenance end point identifier. (Range: 1-8191)
• Status – Enables periodic transmission of loss-measure messages.
• Group Index – Index for a group of loss-measure messages attributes. (Range: 1-200)
To change the binding for a MEP, loss-measure messages must be disabled.
• Target MEP ID – The destination MEP for periodically transmitted loss-measure messages.
(Range: 1-8191)
Configure Dual-Ended LM
• MD Index – Domain index. (Range: 1-65535)
• MA Index – MA identifier. (Range: 1-2147483647)
• MEP ID – Maintenance end point identifier. (Range: 1-8191)
• Status – Enables periodic transmission of loss-measure messages.
• Target MEP ID – The destination MEP for periodically transmitted loss-measure messages.
(Range: 1-8191)
Interface
To add a single-ended loss-measure attribute group:
1. Click Administration, CFM.
2. Select Configure Periodic Loss Measure from the Step list.
3. Select Add Single-Ended LM Group from the Action list.
4. Set the attributes for periodic loss-measure message transmission.
5. Click Apply.
FIGURE 308 Configuring a Single-Ended Loss-Measure Attribute Group