Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide 963
53-1002651-02
43
Simple Network Management Protocol
FIGURE 264 Configuring Local SNMPv3 Users
To show local SNMPv3 users:
1. Click Administration, SNMP.
2. Select Configure User from the Step list.
3. Select Show SNMPv3 Local User from the Action list.
FIGURE 265 Showing Local SNMPv3 Users
Configuring Remote SNMPv3 Users
Use the Administration > SNMP (Configure User - Add SNMPv3 Remote User) page to identify the
source of SNMPv3 inform messages sent from the local switch. Each SNMPv3 user is defined by a
unique name. Users must be configured with a specific security level and assigned to a group. The
SNMPv3 group restricts users to a specific read, write, and notify view.
CLI References
• “snmp-server user” on page 115