Installation guide

Replacing a transceiver
Complete the following steps to replace an SFP or SFP+ transceiver. Refer to the illustration in
Removing a transceiver on page 89.
1. Making sure that the bail (wire handle) is in the unlocked or open position, position the optical
transceiver so that the key is oriented correctly to the port. Insert the transceiver into the port until it
is firmly seated and the latching mechanism clicks.
Transceivers are keyed so that they can only be inserted with the correct orientation. If a transceiver
does not slide in easily, ensure that it is correctly oriented.
2. Position a cable so that the key (the ridge on one side of the cable connector) is aligned with the
slot in the transceiver. Insert the cable into the transceiver until the latching mechanism clicks.
Cables are keyed so that they can be inserted in only one way. If a cable does not slide in easily,
ensure that it is correctly oriented.
QSFP transceiver removal and replacement
Use this procedure to remove and replace a QSFP transceiver. Because each QSFP transceiver
consists of four 10 GbE ports, be aware that any problems with one port could affect all four ports in
the quad.
DANGER
All fiber-optic interfaces use Class 1 lasers.
DANGER
Laser Radiation. Do Not View Directly with Optical Instruments. Class 1M Laser Products.
Removing a QSFP transceiver
Complete the following steps to remove a QSFP transceiver.
1. Remove the fiber-optic cable from the transceiver.
2. If your transceiver has an integrated pull tab, gently pull the transceiver from the port using the tab.
3. If your transceiver as a bail release, as shown in the following figure, complete the following steps.
a) Pivot the bail on the transceiver to the horizontal position.
b) Holding the transceiver by the bail, gently pull the transceiver out of the port.
4. Insert a protective plug into the transceiver and put it aside.
Replacing a transceiver
90 Brocade VDX 8770-8 Hardware Installation Guide
53-1002564-07