Installation guide

FIGURE 25 Removal and replacement of the power supply
Replacing an AC power supply
To replace a power supply, complete the following steps. Refer to the illustration provided with the
procedure.
DANGER
High Touch Current. Earth connection essential before connecting supply.
CAUTION
If you do not install a module or a power supply in a slot, you must keep the slot filler panel in
place. If you run the chassis with an uncovered slot, the system will overheat.
1. Unpack the new power supply and remove it from the anti-static bag.
2. Inspect the power supply for damage.
3. Ensure that the handle of the replacement power supply is pushed down.
4. Insert the power supply into the slot.
5. Rotate the handle upward to fully seat the power supply.
6. Tighten the captive screw. Replace the power cord.
7. Latch the power cord retainer clip.
8. Verify that the power LED on the power supply displays a steady green light.
Replacing an AC power supply
Brocade VDX 8770-8 Hardware Installation Guide 81
53-1002564-07